切割方法:
Cutting method:
一、热熔线切割用电阻丝加热切割。
1. Heat resistance wire heating and cutting for hot melt wire cutting.
二、用刀片直接切割。
Two, with the blade direct cutting.
三、用胶或酸腐蚀法。
Three, with gum or acid etching method.
表面处理: 一、钢锯条反复刮出造型。
Surface treatment: a hacksaw, repeatedly scraped out of shape.
二、用大齿锯刮出特殊机理。
Two, with a large saw scraping mechanism.
三、用电阻丝溜平。
Three, with resistance wire leveling.
颜色处理:
Color processing:
一、喷漆。
One, spray paint.
二、粉彩上色,丙烯上色。
Two, pastel colored, acrylic color.
注意事项:苯板雕塑着色是不能直接喷漆的。要先涂一层保护层以避免挥发物将苯板融化。保护层涂
Note: the benzene board sculpture coloring is not directly spray paint. First, a layer of protective layer is to be applied to avoid the volatile matter to melt the benzene plate. Protective coating
好晾干后才可以涂刷或喷漆。涂层可以用 立德粉、白乳胶、少[1]量水 调至而成。
Good air can be painted or spray paint. The coating can be used lithopone, white latex, less amount of water to a [1].
注意:先用小块苯板试验。因为现在的劣质白乳胶太多。
Note: first with small piece of benzene board test. Now because of the poor white latex too much.
咨询电话:15978409299
微 信:15978409299
咨询 QQ:2764182758
官方网站:
微信平台:jinlancaobihua
博 客:
http://blog.sina.com.cn/jinlancao
公司地址:中国。郑州东区
商都路与站南路交汇建正东方中
心A座2308室
工厂地址:郑州市科学大道与淮阳路交汇北500米。